![]() Note : The pre-assembled hardware on the axis takes into account the motors dimensions. If the pool itself is not straight, this will also cause the shutter covers slats to be out of line. If this is the case, unrolling will equally cause friction with pool wall with the shutter cover. This causes the layers of slats to be out of line. Under-Track Pulley Housing for Small Channel Track - Right. Automatic Pool Covers (APC) OEM Part MC0205. Most can be replaced individually or complete assembly (if necessary). Incorrect positioning will provoke the incorrect rolling of the cover. They also attach to mechanism motor and non-motor brackets. The straps should be fitted in their respective supports which can be adjusted in relation to the shutter cover. The first module of the slats is equipped with weaved nylon straps 50mm wide. Once the shutter cover has been assembled, it should be fixed to the rolling axis. To simplify assembly, the slats should be placed, by module, on water.įixation of the shutter cover on the axis This module should be positioned at the extremity of the shutter cover which is opposite to the rolling axis. One of the modules is equipped with obliged security straps. The other slats are delivered in modules of 3 or 6 elements. The first module of the shutter is delivered with fixation straps attached to the axis. The slats must be stocked in the shade, with an air temperature lower than 40°c. ![]() The assembly of the shutter can only be undertaken if there is water in the pool. The Advanced T4 automatic cover system is now available for your spa. Note: This range is a basic estimate, exact pricing will vary. For a larger pool with more complex features, a safety cover can cost upwards of 20,000. If this option is used it must be installed in a position where the pool is visible during each opening and closing unit.ĭuring the installation, if the key control cable terminals are inverted and the shutters action does not correspond to the open and close position on the box, cross the cable terminals "F and O" in the control box. An automatic safety cover can start as low as 10,000 for a small, aftermarket deck install or a basic under track setup.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |